Garage door springs are under a lot of tension, so it’s important to be careful when working on them. If the springs are broken, they will need to be replaced. Here are the steps to replace a garage door spring:
- Open the garage door and disconnect the opener by pulling the red release cord.
- Remove the screws that hold the spring brackets in place and take the brackets off.
- Cut the old springs with a hacksaw and remove them from the brackets.
- Install the new springs in the brackets and reattach the brackets.
- Reconnect the opener and test the garage door.
Garage door springs are an important part of your garage door system. They help to lift and lower the door, and they also keep the door balanced. When a spring breaks, it can cause the garage door to become unbalanced and difficult to open and close.
If you are having problems with your garage door, it is important to have the springs inspected by a professional. Garage door springs can be dangerous if they are not handled properly, so it is always best to leave the repairs to a professional.
If you are thinking about replacing your garage door springs, it is important to know that there are two types of springs: torsion springs and extension springs. Torsion springs are located above the door, and extension springs are located on the side of the door.
When choosing new springs, be sure to select the same type as your old springs. Also, be sure to get the right size. If the new springs are too small or too large, they will not work properly and could damage the garage door system.
If you are not sure which springs you need, or if you need assistance with replacing your garage door springs, please contact a professional garage door repair company.